Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Installationshandbuch Seite 11

8
[Fig. 8.1.0.4]
[Fig. 8.1.0.5]
Rear side
<A>
[Fig. 8.1.0.6]
A
B
A
<A> Screw down the metal sheet wiring cover at three points.
A Cover wiring 1
<A>
B Cover wiring 3
B
<B>
B
<A> Pull up the panel heater wirings so that the wirings run along the right rear pillar.
<B> Thread the wiring through the hole on the right rear pillar and bring it into the inner
side of the heat exchanger.
A Panel heater wiring
B Right rear pillar
C Right frame
D Heat exchanger fixing plate
E Wire seal
* If the wiring comes in contact with the edges of the heat exchanger fixing plate, place
the supplied wire seal.
<A> Screw down the metal sheet wiring cover at three points.
<A> A Cover wiring 1
B Cover wiring 2
8.1.0
C
A
D *
E
A
11