Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Installationshandbuch Seite 14

8
[Fig. 8.1.1.5]
A
Right rear side
B
A
<C>
<B>
Right rear side Left rear side
[Fig. 8.1.1.6]
A
B
14
Left rear side
<A>
C
<A> Pull up the panel heater wirings so that the wirings run along each pillar.
<B> Thread the panel heater wirings through the long hole on the right rear pillar.
<C> Run the panel heater wirings between the left rear pillar and the heat exchanger.
<D> Pull the wirings from the end of the heat exchanger and bring them into the
inner side of the heat exchanger.
<E> Attach the rubber sheet to the left frame so that the heat exchanger fin will be
covered. (Using the wiring access hole and the tab on the frame as a
reference position)
<F> Thread the wirings through the hole on the left frame, and bring them into the
inner side of the heat exchanger.
A
A Panel heater wiring
C Left rear pillar
E Left frame
G Heat exchanger fixing
plate
*1 If the wiring comes in contact with the edges of the heat exchanger fixing plate,
place the supplied wire seal.
*2 If the frame is not painted, place the supplied wire
seal around the hole.
<A>
C
8.1.1
D
A
<D> Right rear side
E
* 2
A
B Right rear pillar
D Right frame
F Plate rubber
H Wire seal
A
<A> Screw down the metal sheet wiring covers at three points.
A Cover wiring 1
B Cover wiring 2
C Cover wiring 3
G*
F
Left rear side
Hole
Tab
H
Left rear side
1