Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Installationshandbuch Seite 10

8. Electrical Wiring
Step 1. Panel heater wiring
8
S-module
[Fig. 8.1.0.1]
A
Left side
[Fig. 8.1.0.2]
A
<A>
[Fig. 8.1.0.3]
Right side
10
8.1.0
B
A
<A>
<A> Pull up the panel heater wirings so that the wirings run along the left rear pillar.
<B> Thread the panel heater wirings through the long hole on the left rear pillar.
<C> Attach the rubber sheet to the left frame so that the heat exchanger fin will be covered.
(Using the wiring access hole and the tab on the frame as a reference position)
<D> Pull the wiring through the hole on the left frame and bring it into the inner side of the
heat exchanger.
A Panel heater wiring
B Left rear pillar
C Left frame
D Plate rubber
E Wire seal
* If the frame is not painted, place the supplied wire seal
around the hole.
C
B
<B>
<A>
A B
<A> Pull up the panel heater wirings so that the wirings run along the right rear pillar.
<B> Thread the wiring through the hole on the right rear pillar and bring it into the inner
side of the heat exchanger.
A Panel heater wiring
C Right frame
E Wire seal
* If the wiring comes in contact with the edges of the heat exchanger fixing plate, place
the supplied wire seal.
*C
<B>
A
<A> Screw down the metal sheet wiring cover at three points.
A Cover wiring 1
B Cover wiring 2
C Cover wiring 4
C
A
B Right rear pillar
D Heat exchanger fixing plate
D
<C, D>
Hole
Tab
E
D*
E