Maintenance - Scheppach wox d 700 Bedienungsanleitung

Maintenance

Before starting the maintenance or checks, clean the work area and have suitable tools at hand and in good condition.
The time intervals cited here relate to normal operating conditions. If the machine is subjected to heavier loads, these times must
be reduced accordingly.
Clean the machine cladding, panels and control levers with a soft, dry cloth or a cloth that has been slightly moistened with neutral
cleaning agent. Do not use any solvents such as alcohol or petrol as these may damage the surfaces.
Keep oils and lubricants out of reach of unauthorised persons. Read through the instructions on the containers carefully and
follow them closely. Avoid direct contact with the skin and wash off thoroughly after use.
Only carry out modifications, adjustments and cleaning work when the engine is switched off.
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore
also required for use as consumables.
Wear parts*: Saw blade, rocker insert
* Not necessarily included in the scope of delivery!
Servicing
Switch the engine off and let it cool down. Pull the mains plug out of the outlet. Disconnect the drive shaft connection to the tractor.
Check the general condition of the machine. Check for loose screws, misalignment or jamming of moving parts, part breakages
and other conditions that could impair safe operation.
Remove all foreign objects and other materials that have collected on the chain and on the unit. Clean the machine after every
use. Then use a high-quality, low-viscosity machine oil to lubricate all moving parts.
Experienced craftsmen can carry out small repairs on the machine themselves.
• Check the saw blade at regular intervals. Use only saw blades that are well sharpened, free of cracks and not deformed. Only
use tools that comply with the European standard DIN EN 847-1.
• Replace worn rocker inserts immediately.
• Check all safety devices after all maintenance or cleaning work.
• Check that no tools or miscellaneous parts are on or in the machine before putting it back into operation.
• Remove any sawdust accumulations that may arise at the discharge.
• Check the oil level before every use. Remove the plug (Fig. 4; B) and check that the oil level lies between the two marks whilst
the machine is horizontal. Top up the oil if required. (see engine manual)
Angular transmission oil change:
• Replace the transmission oil annually.
• Use SAE 90 transmission oil.
• The capacity is 0.66 litres.
• Remove the angular transmission oil filler plug.
• Fill until the oil reaches just underneath the edge of the filler port.
• Dispose of used oil in an environmentally friendly manner!
m
Never use a high-pressure cleaner to clean your machine. Water can penetrate sealed areas of the machine and the
transmission housing and cause damage to spindles, gear wheels, bearings or the engine. The use of high-pressure
cleaners shortens the service life and reduces the ease of maintenance.
Seite:80
GB