Side Broom Height Check And Adjustment; Side Broom Disassembly/Assembly - Nilfisk SW900 Betriebsanleitung

SIDE BROOM HEIGHT CHECK AND ADJUSTMENT

NOTE
Brooms with harder or softer bristles are available.
This procedure is applicable to all types of brooms.
NOTE
This procedure is applicable to both the right side
broom and left side broom (optional).
Check
Drive the machine on a level loor.
1.
2. Turn the ignition key (2) to "I".
3. Lower the side broom with the lever (12).
4. The proper side broom height is reached when the bristles
touch the loor along a circle arc as shown (A, Fig. 5).
If the print (A) is not within speciications, adjust the broom
height.
Adjustment
5. Turn the ignition key (2) to "0".
6. Loosen the nut (C, Fig. 6) under the cover (B) and turn the
screw (D) clockwise or counter-clockwise to increase or
decrease the side broom height. Then lock the screw with
the nut.
7. Perform step 4 again to check that the side broom is at the
correct distance from the ground.
8. When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.
CAUTION!
If the side broom print is excessive, the machine
regular operation is affected and the moving
parts or electrical components can overheat, thus
reducing machine life.

SIDE BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to wear protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
NOTE
This procedure is applicable to both the right side
broom and left side broom (optional).
Drive the machine on a level loor.
1.
2. Turn the ignition key (2) to "0".
3. Loosen the knob (A, Fig. 7) inside the side broom, then
remove the broom (B) by disengaging it from the three pins
(C).
4. Install the new broom on the machine engaging it on the
pins (C), then tighten the knob (A).
5. Adjust the height of the new broom according to the
procedure shown in the previous paragraph.
USER MANUAL
A
Figure 5
B C
Figure 6
B C A C
Figure 7
1465366000 - SW900
ENGLISH
P100820
D
P100821
C
P100822
17