Torque value of clamping screw: 3 Nm (2.2 ft. lbf. / 26.5 lbf.in.).
Torque value of adjustment screws of the adapters: 9 Nm (6.5 ft. lbf. / 80 lbf. in.)
Use 710D4 Torque Wrench.
Secure the screws by means of 636K13 Loctite.
7 Cosmetic foam cover
Use the 3R48 Foam Cover for Knee Joint 3R65.
Attention!
Do not use talcum powder to eliminate noise in the cosmetic foam cover. Talcum powder
reduces the lubrication of the mechanical parts, which may lead to a malfunction and
thus increase the risk of failure. Using this medical product after application of talcum
powder will render all claims null and void.
Note:
To reduce friction and to eliminate noise, please apply 519L5 Silicone Spray directly on
the contact surfaces of the cosmetic foam cover.
8 Maintenance instructions
Attention!
Do not disassemble the joint! In case of any problems please return the entire joint to
Ottobock.
Please examine the modular knee joint after it has been in use for a few weeks as well as
every three months and make any necessary adjustments. Whenever servicing the knee,
replace the Rubber Stop.
8.1 4D17 Single-component-pack
Consisting of 1 oval head screw, 1 rubber stop.
9 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip-
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.
9.2 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC for medical devices.
This product has been classified as a class I device according to the classification criteria out-
lined in Annex IX of the directive. The declaration of conformity was therefore created by the
manufacturer with sole responsibility according to Annex VII of the directive.
3R65
Ottobock | 9