Newtron Function - Satelec ACTEON Implant Center 2 Benutzerhandbuch

a) Audio volume adjustment
Adjust the audio volume value
buttons and
volume is adjustable from 0% to 100%.
The relative value of the audio volume is displayed
(Fig. 10-48).
b) Screen brightness adjustment
Adjust the brightness value
buttons and
brightness is adjustable from 30% to 100%.
The brightness level setting is displayed (Fig. 10-49).
c) Light off time-out adjustment
Adjust the time-out length value
pressing buttons
The length of the adjustable time-out (from nine
seconds to 18 seconds) is displayed (Fig. 10-50).
I-S mode:
URGE
Contra-angle
Program
P1
P2
P3
P4
16
(Fig. 10-43) using
(Fig. 10-46 and 47). The audio
(Fig. 10-44) using
(Fig. 10-46 and 47). The
(Fig. 10-45) by
and (Fig. 10-46 and 47).
Speed at
ratio instrument end
20:1 1200 rpm
20:1 800 rpm
20:1 15 rpm
20:1 30 rpm
d) Storing the settings
To store the modified settings, press button
10-52). The screen shown in Fig. 9 reappears.
e) Factory configuration reset
Press button
factory configuration settings.
The factory configurations for the P
N functions are effective when button
EWTRON
(Fig. 10-52) is pressed. The screen shown in Fig. 9
reappears.
f) Software version
The version of the software is displayed at the
bottom of the screen (Fig. 10-51).
I C
MPLANT ENTER
following settings:
Torque at
Irrigation
instrument end
80 N.cm 80 ml/min.
80 N.cm 100 ml/min.
20 N.cm 100 ml/min.
20 N.cm
(Fig. 10-42) to restore the
2 is configured in the factory with the
Implant site marking
Pilot drilling
Boring / tapping
0
(Fig.
and
IEZOTOME
Functions
Screwing