Newtron Function; Toolbox - Satelec Implant Center Benutzerhandbuch

The storing of the various settings is confirmed by
an audible signal and by the symbol
blinks on the screen.
Repeat this sequence if necessary in order to
adjust all the programs.

7. 6 NEWTRON FUNCTION

Important:
A scaler cord and its N
be connected to the device in order to be able
to select the various settings.
Select the N function by pressing the right
EWTRON
selection button (Fig. 3-10).
On the LCD screen, the N
highlighted (Fig. 7).
Select the program to be adjusted
(Fig. 3-5); the selected mode is displayed on
the LCD screen and an indicator corresponding to
the SATELEC color code (CCS) lights up (Fig. 3-
24).
Adjust the power level according to the Tipbook™
recommendations using the
3-7 and 9). The power level is displayed on the
screen (Fig. 7).
If necessary, modify the Irrigation function (flow
rate value, etc.), then press button
Confirm the mode settings by pressing button .
The storing of the various settings is confirmed by
an audible signal and by the symbol
blinks on the screen.
Repeat this sequence if necessary in order to
adjust all the programs.
14
which
handpiece must
EWTRON
tab must be
EWTRON
, ,
or button (Fig.
.
which

7. 7 TOOLBOX

Important:
- The adjusted
effective when the device is restarted.
- The function is exited by switching off
TOOLBOX
the device.
The I C
MPLANT ENTER
make various adjustments, including contrast,
light off time-out (option) and reboot in factory
configuration.
To access the
device, then press buttons
9) simultaneously while switching the device on
again. Release the buttons when the
screen is displayed (Fig. 10).
or To select a setting, press button
mark is displayed next to the selected setting.
a) Contrast adjustment
Confirm access to setting
The cursor is displayed under the contrast value.
Adjust the contrast value using the
buttons (Fig. 3-7 and 9).
The contrast is adjustable from 1 (lightest) to 50
(darkest).
Confirm the value by pressing button
b) Light off time-out adjustment
Confirm access to setting
The cursor is displayed under the time-out value.
Adjust the time-out value from 0 to 10 by
pressing the
The time-out value is adjustable from 0 (no time-
out) to 10 (10 seconds).
Confirm the setting by pressing button
settings become
TOOLBOX
has a function used to
TOOLBOX
function, switch off the
TOOLBOX
and
by pressing button .
by pressing button .
and buttons (Fig. 3-7 and 9).
(Fig. 3-7 and
TOOLBOX
; a check
and
.
.