Herunterladen Inhalt Inhalt Diese Seite drucken

Roland BA-330 Bedienungsanleitung Seite 18

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23
Convenient Features
Using a speaker stand (Option: ST-A95)
By using a speaker stand (Option: ST-A95), you can mount the BA-330 at the optimal height for use as a monitor speaker or simple PA device.
Attachment procedure
Always have at least one other person assist you when
mounting the BA-330 on a speaker stand, or when adjusting the
height of the stand while the BA-330 remains mounted on it.
Be careful not to pinch your fingers, when you assemble.
Stopper
Tripod
1.
Loosen
and open the tripod.
tripod knob
After opening the tripod, tighten the tripod knob again.
*
The distance between lower ends of the tripod should be 98cm
as shown in figures on the below. If the tripod is not opened wide
enough, the stand may be unstable.
Diameter:
112 cm or more
(44-1/8")
2.
Loosen height adjustment knob and make upper tube
longer.
3.
Set up upper tube at the required height and insert the
stopper into the hole in upper tube (refer to following
figure).
Stopper
*
Use the ST-A95 only with the stopper inserted into upper tube.
4.
Tighten height adjustment knob.
5.
Fit the hole on the BA-330 onto upper tube.
16
Upper tube
Height adjustment knob
Tripod knob
Leg spread: 98 cm or
more (38-5/8")
WARNING
The BA-330 is designed to be used in combination with the speaker
stand manufactured by Roland (ST-A95). Please do not use any
other stands.
Before use, adjust the speaker stand to a height of 130 cm (51-3/16")
or less and a leg spread of 98 cm (38-5/8") or more, as shown in the
figure below.
98 cm or more (38-5/8")
Using a speaker stand that does not meet the specifications at left
or that is adjusted to a height over 130 cm (51-3/16"), or a leg spread
of less than 98 cm (38-5/8") may result in damage to equipment or
injury due to the stand tipping over.
When using BA-330 with a speaker stand, the speaker stand must be
carefully placed so it is level and sure to remain stable.
Cables connected to BA-330 should be given enough slack to pre-
vent accidents that might result from someone tripping over them.
To prevent accidents due to falls, do not place any object on the
BA-330 when it's mounted on a speaker stand.
130 cm or less
(51-3/16")

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis