Roland BA-330 Bedienungsanleitung Seite 17

Connections that allow the input jacks of
both units to be used
This arrangement lets you play in stereo, making maximum use of
the two BA-330s' mixer functions (with 12 inputs).
L
CH 1�6 �6 6
AUX IN
1.
Connect the devices to the BA-330 (L) and BA-330 (R).
2.
Connect the STEREO LINK OUT R jack on the BA-330 (L)
and the STEREO LINK IN jack on the BA-330 (R).
3.
Connect the STEREO LINK OUT L jack on the BA-330 (R)
and the STEREO LINK IN jack on the BA-330 (L).
4.
Turn on both BA-330 (L) and BA-330 (R).
5.
Adjust the volume levels on all devices.
6.
Adjust the BA-330 (L) and BA-330 (R) volume levels sepa-
rately using their [VOLUME] knobs.
Adjusting the volume and tone quality
Adjust the L and R volume levels separately using their MASTER
[VOLUME] knobs. You can adjust the EQUALIZER ([LOW]/[HIGH]
knobs) independently for the L and R sides. Basically, they should be
set to the same positions, but you can adjust each one as necessary
to suit the needs of a particular setup.
Using a stand
Using the BA-330's stand
When using the BA-330 on floors, or in other low-lying positions,
then setting up and using the arm stand can make it easier to hear
the sound from the speakers.
Using the arm stand
1.
Turn the BA-330 over and raise the arm stand.
R
CH 1�6 �6 6
AUX IN
2.
Place the BA-330 on a flat and level surface.
• When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
• When using the arm stand, always be sure to place it so the BA-330
remains level.
• When not using the arm stand, fold it up.
• Never lift up and carry the BA-330 by holding the folding stand.
• Never place any objects on top of the BA-330 when using the arm
stand. Also, never sit or lean on the folding stand.
• When folding the folding stand, be careful not to pinch your fingers.
Convenient Features
Arm stand
CAUTION
15