Roland BA-330 Bedienungsanleitung Seite 13

Jack panel
Input (INPUT) jacks CH1, CH2: monaural
Connect the following equipment
If something is connected to both the XLR
connector and phone connector at the same
time, the phone jack will be given priority.
Wiring diagrams for these jacks are shown below. Make connections
after first checking the wiring diagrams of other equipment you
intend to connect.
HOT
TIP HOT
RING COLD
SLEEVE GND
Input (AUX IN) jack
Connect the following equipment
• CD player
• Portable audio player, etc.
• Computer, etc.
Use the [LEVEL] knob to adjust the
volume.
The RCA phono jacks and mini-jack can be
used simultaneously.
Stereo link (STEREO LINK) jacks
These jacks are used when you want to
connect two BA-330 units to create a
stereo system with greater output power.
For details, refer to "Connecting an addi-
tional unit to increase the output (Stereo
Link)" (p. 14).
• Microphone
• Musical instrument (Guitar, etc.)
GND
COLD
Output (LINE OUT) jacks
Connect these jacks to your
mixer or recorder.
If you're outputting in monaural,
connect the L/MONO jack.
The EQUALIZER knobs and the
MASTER [VOLUME] knob do not
affect the LINE OUT jacks.
Input (INPUT) jack CH3/CH4: stereo
CH5/CH6: stereo
Connect the following equipment
•
•
•
•
•
If you're using a monaural source, connect it to
L/MONO (CH4 or CH6).
* This will accommodate a player
You can place your
of up to the following size.
portable audio
Width: 144 mm
player here.
Depth: 22 mm
FOOT SW jack
You can use a foot switch to turn MUTE
(FS-5L) and EFFECT (FS-5U) on/off.
For details, refer to p. 9.
If only one foot switch is connected
using a monaural cable, only the MUTE
function can be switched.
Controls and connectors
Keyboards
Line-level devices
Guitar
CD player
Portable audio player, etc.
AC adaptor (DC IN) jack
Connect the included AC adap-
tor here.
* You can also connect the
commercially available cable
for an external power device.
11