Sticker; Truma Manufacturer's Warranty - Truma DuoControl CS Gebrauchsanweisung, Einbauanweisung

– Fasten to a stable wall / ceiling with 4 screws.
Ensure the component is firmly attached.
– Connect the 8-mm or 10-mm gas supply pipe to the regu-
lator outlet according to the respective installation instruc-
tions for olive screw connections (e.g. EN ISO 8434-1).
When tightening, carefully use a second spanner on the
provided spanner surfaces to keep the entire assembly from
turning.
– Screw high-pressure hoses (only with HRP) to the
DuoControl CS inlets, using angle unions if necessary .
– When the installation operation has been completed,
arrange for the entire gas system to be leak-tested and
checked by a specialist technician to ensure correct installa-
tion. Check the hose connections at the DuoControl CS inlet
for leaks (e.g. using a leak finder spray in accordance with
EN 14291). If a gas testing certificate already exists it must
be supplemented / updated accordingly.
This test does not replace the regularly scheduled gas
check!

Sticker

The provided sticker must be affixed in the cylinder box.
Then all functions must be tested in accordance with the op-
erating instructions.
The operating instructions must be handed over to the vehicle
operator.
20

Truma Manufacturer's Warranty

1. Warranty claims
The Manufacturer hereby warrants for all defects of the unit
caused by material or production faults. In addition, the seller
continues to be subject to any statutory warranty claims.
No warranty claim shall be applicable under the following
circumstances:
– Consumable parts which are subject to wear and tear
– Use of parts other than original Truma components in any
of the units
– In gas pressure regulation systems: damage caused by for-
eign substances in the gas (e.g. oils, plasticisers)
– Failure to observe Truma's installation or operating
instructions
– Improper handling
– Improper transport packing