Leckey Mygo Max Benutzerhandbuch Seite 38

The powered chassis can be easily adjusted
with the push button control handset. The
seat can be height adjusted with the client
in the chair. When one of the buttons on
the handset is pressed, then the seat will
move up or down in that direction until the
button is released again, or if the actuator
has reached the end of its stroke.The system
is started by inserting the battery into the
circular holder in the end of the control
box. Clean the magnetic poles for all dirt
or metal chips before inserting. The battery
will magnetically hold itself in place with the
correct position , and a confirming long beep
is heard.
The control box checks the battery level
every 24 seconds, and when the battery
reaches a low limit, then the control box will
give a double-beep every 24 seconds to
indicate that the battery needs recharging.
This is done in the "C3-charger", full
re-charging takes 5-8 hours, depending
on state of charge. To remove the battery,
turn it 90 degrees (right- or left) to release it
from the magnets . The battery (NiMH-type)
can be recharged from any state of charge
without reducing battery life or battery-
capacity.
When connecting the "C3-charger" to the
mains (100 – 240 V AC), the red diode lights
up continuously and a single flash in the
green diode appear before it turns off again.
When inserting the battery into the charger,
the green diode starts flashing with an
interval of 1/sec during the charging process.
When charging is finishing, the green diode
stops flashing and turns on continuously, the
battery is fully charged, can be removed and
is ready for use in the C3 controller.