6.6.4 Fixing the base to the support
For further details on configuration and
use, refer to the manual of the relevant
accessory or support.
6.6.5 Sunshield mounting
You can fix the sunshield to the housing using the
screws supplied.
Pay attention to the fixing. Tightening
torque: 1.6Nm (±0.2Nm).
Fig. 12
Standard installation of the product.
Fig. 13
Installation of the product overturned.
MNVCEVO_1909_EN
6.6.6 Fastening of the safety coupling
Take special care when attaching and
fastening down the apparatus. If it is to be
attached to a concrete surface you must
use dowel pins with a traction torque rating
of at least 300dN each. For a metal surface
use screws with a diameter of at least 8mm
and of an appropriate length. The fastening
system must be capable of supporting
at least 4 times the weight of the entire
equipment (pan & tilt, lens, camera,
supports and adapters).
Use an external anchor point to fix the
chain or the safety cable to the unit support
surface. Choose a chain or safety cable
capable of supporting 4 times the weight
of the unit, including its brackets and
adaptors.
Pay attention to the fixing. Tightening
torque: 4.5Nm (±0.2Nm).
Apply threadlocker in the holes of the
screws (Loctite 243®).
The product is equipped with a safety coupling to
secure the product and a second fastening point
using the chain.
Position the safety coupling and fix it with the screw
and the washer supplied as shown in the figure.
Fig. 14
17