Getting Started - Cochlear Baha Intenso Bedienungsanleitung

English

Getting started

Connecting and disconnecting the sound processor
A plastic snap connector is mounted to the sound processor. It is designed to
snap onto the abutment and hold the sound processor securely in place.
Connecting Hold the sound processor so that the plastic snap connector
is accessible and move any hair away from the abutment. Push the sound
processor carefully in with a tilting motion and it will attach to the abutment.
Disconnecting Tilting the sound processor slightly in any direction will release
it from the abutment.
Warning! Do not push the sound processor straight in and do not
pull it straight out. This puts pressure on the abutment and may
cause discomfort.
On/Off
Off When the volume control is in the 0 position it is off. You will feel
a "click" as it goes into off mode.
6
On For the sound processor to be on, the volume control must be set to a
position higher than 0. You will feel a click as the sound processor moves from off
mode to on mode.
Volume control If you turn the volume control upwards the volume increases,
and if you turn it downwards it will decrease.
3
Program selector
As you change from one program to another sounds signal which program
0
you enter. One beep for program one, two for program two and three beeps for
program E.
Program 1 Program one is the "normal setting", suitable for most everyday
sound environments.
Program 2 For comfort and convenience program two has a higher bass cut
setting that some people will find useful for reducing background noise in loud
environments.
1
Program E This program is used when connecting electrical accessories such as
2
the audio adapter or telecoil. If no accessory is connected, there will be no sound
E
from the device even if it is on.
English
7