Troubleshooting - Panasonic ES-LV6N Betriebsanleitung

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the store
where you purchased the unit or a service centre authorized
by Panasonic for repair.
Problem
The power switch does
not turn ON.
The clean lamp ( ) glows.
(It turns off in about
1 minute.)
The shaving sensor
does not respond.
18
Action
Unlock the switch lock.
(See page 14.)
Please clean the blades with the
sonic vibration cleaning mode.
Depending on the beard
thickness or the amount of beard
trimmings in the shaver head,
the shaving sensor may not
react and the driving sound may
not change. This is not abnormal.
The shaving sensor may not
respond depending on the type
and quantity of the shaving gel.
This is not abnormal.
The shaving sensor may not
respond when the remaining
battery capacity is low. If this
happens, recharge the shaver.
Apply oil. (See page 16.)
The shaving sensor may not
respond when there is not
enough oil on the blades.
Problem
The shaving sensor
responds even though
the shaver is not in
contact with the skin.
Operating time is short
even after charging.
Shaver does not operate
even after charging.
Action
Clean the beard trimmings from
the shaver.
When the shaver is extremely
dirty, remove the foil frame and
wash with water.
(See page 15.)
Replace the system outer foil
and/or inner blades.
Expected life of system outer
foil and inner blades:
System outer foil:
Approximately 1 year
Inner blades:
Approximately 2 years
Apply oil.
When the number of operations
per charge starts to decrease,
the battery is nearing the end of
its life.
The appliance may not operate
in an ambient temperature
approximately 5 °C or lower.
The battery has reached the
end of its life.
The shaver will not operate with
the AC adaptor connected.
Please use the shaver after it has
been sufficiently charged and the
AC adaptor disconnected.