Replacement Parts; Troubleshooting - Panasonic ER-RZ10 Bedienungsanleitung

Charging stand
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
Lubrication
• Apply the oil to the trimmer before and after each use.
Apply a drop of the oil to each indicated
point.
Attach the blade to the main body, turn
on the power and allow to run for
approximately 5 seconds.
Failure to apply the oil may cause the
following problems due to rust, wear or
burn out.
‑ The trimmer has become blunt.
‑ Shorter operating time.
‑ Louder sound.

►Replacement parts

Replacement part is available at your dealer or Service Centre
Replacement parts for ER‑RZ10
12
ER-RZ10_EU.indb 12
Blade WER9340

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service centre authorized by
Panasonic for repair.
Problem
Until problems are solved, please
follow each procedure as follows;
The trimmer has become 1. Charge the trimmer.
blunt.
2. Clean the blade and apply oil.
Operating time is short.
3. Replace the blade.
Trimmer stopped functioning.
4. Have the battery replaced by
Insert the appliance plug into the
trimmer firmly.
The trimmer cannot be
Charge within the recommended
charged.
charging temperature of 0 °C to
35 °C.
Apply oil. (See this page.)
Makes a loud sound.
Confirm that the blade is properly
attached.
Action
(See page 10.)
(See pages 11 and 12.)
(See page 11.)
an authorized service centre.
2017/01/13 11:02:01