Troubleshooting; The Toilet Is Noisy; Water Is Added But The Pump Fails To Flush - Tecma Privilege Bedienungs- / Installations- / Wartungshandbuch

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege/ Evolution/ Breeze/ E-Breeze/ Silence Plus 2G/ Elegance 2G
**refer to each model PIS to check if the bidet function is available with integrated or wall mounted mixer
Any other commercial handle/mixer can alternatively be used to mix the water
The customer is free to select a wall mounted mixer from the same collection of the bathroom,
and use it to control the bidet integrated in the toilet. In this case do not use the mixer provided
and install the mixer/handle that you prefer. Make sure to do the plumbing right. In case of any
doubt contact Tecma technicians.
4.0

Troubleshooting

4.1 Toilet is noisy
The pump may be partially blocked if a solid object or paper other than toilet paper has been
flushed. Flush repeatedly. If the problem persists, open and inspect the macerator pump. Contact
a TECMA service centre, which will provide qualified assistance. Check the position of the sleeves
if the water flow generates excessive noise, especially at the end of flushing.

4.2 Water is added but the pump fails to flush

There might be a problem with the motor or control panel. Use a tester to check whether the
panel provides current to the motor or not.
If both the panel and motor run correctly, make sure that the sleeves are mounted correctly and
are not obstructed.
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy-
Manual rev1.6.2015 1111111111111111
Mixer OD 42 mm
Length 55 mm (chromed part)
MACERATOR TOILETS
TOILET MACERATRICI
www.thetfordmarine.com
111111111111111111111
68