Touch Control Panel; One Button; Two Buttons - Tecma Privilege Bedienungs- / Installations- / Wartungshandbuch

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege/ Evolution/ Breeze/ E-Breeze/ Silence Plus 2G/ Elegance 2G
2.4

Touch control panel

2.4.1 One button

Press the "AFTER USE" touch button to start the automatic flush cycle, after which the toilet will
be refilled with a small amount of water, ready for the next use.

2.4.2 Two buttons

Press the "BEFORE USE" touch button before using the toilet. This will fill the toilet with a small
amount of water. Press the "AFTER USE" touch button after using the toilet. This will start the
automatic flush cycle, which will empty the toilet. The Touch Panel two buttons locks the "Before
Use" button when the tank level Led turns red (tank full).
BEFORE USE
NOTE: It is also possible to adjust the amount of water used during every flushing cycle directly
from the connected remote control unit. A specific regulator placed on its rear increases the
amount of water if turned clockwise, or decreases it if turned anticlockwise.
The recommended water level is 1 cm above the ceramic outlet.
The one- and two-button Touch panels allow you to program the control panel backlight or to set
the panel on standby before starting the cleaning procedure described in paragraph
2.5.3.2.
WARNING: The tank level LED is only an indicator. Do not use the system if the LED is red.
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy-
Manual rev1.6.2015 1111111111111111
MACERATOR TOILETS
TOILET MACERATRICI
TANK LEVEL
www.thetfordmarine.com
111111111111111111111
AFTER USE
AFTER USE
TANK LEVEL
45