Disabling For Cleaning And Led Programming - Tecma Privilege Bedienungs- / Installations- / Wartungshandbuch

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege/ Evolution/ Breeze/ E-Breeze/ Silence Plus 2G/ Elegance 2G
2.5.3.2 Disabling the toilet for cleaning operations and Programming the backlight.
Temporarily disable the buttons in order to clean the Touch control panel.
1. Place your hand on the panel for 15 seconds (as shown in the figure) until the backlight
starts blinking.
2. Clean the panel with a cloth.
3. The buttons will be automatically enabled again after 15 seconds.
You can program the Touch panel to have the backlight:
a. Always on
b. Always off
c. Activated with a proximity sensor (default)
Instructions to switch from one program to another:
1. Press and hold the LED at the centre (Tank level LED)
2. While you hold the centre LED down, simultaneously press and release the BEFORE USE
and AFTER USE buttons. This way, you will switch from one program to another
simultaneously  ALWAYS ON  ALWAYS OFF  PROXIMITY
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy-
Manual rev1.6.2015 1111111111111111
MACERATOR TOILETS
TOILET MACERATRICI
www.thetfordmarine.com
111111111111111111111
51