HAPRO INNERGIZE HP8550 Bedienungsanleitung Seite 13

Problem
The appliance does not
work.
The top of the control
panel becomes hot during
use.
The fuse of the circuit to
which the appliance is
connected cuts off the
power when I switch on or
use the appliance.
The tanning results not as
good as I expected.
The appliance does not
produce enough
fragrance.
The display shows 'Err'
(HP8565 only) and/or the
appliance beeps.
Solution
The plug may not be inserted properly in the wall socket. Put the plug
properly in the wall socket.
There may be a power failure. Test if the power supply works by connecting
another appliance.
The tanning lamps may still be too hot to go on. Let them cool down for 3
minutes first.
The overheat protection may have switched off the appliance
automatically because it overheated. Remove the cause of overheating
(e.g. a towel that blocks one or more vents). Let the appliance cool down
for a while and then switch the appliance back on.
Make sure the lamp unit is in the right position. See chapter 'Preparing for
use' .
The lamps heat up the top of the control panel. This is normal.
The fuse of the circuit to which the tanning appliance is connected must
be a 16A standard fuse or a slow-blow automatic fuse. You may also have
connected too many appliances to the same circuit.
Perhaps you use an extension cord that is too long and/or does not have
the correct current rating. Consult your dealer. Our general advice is not to
use an extension cord.
You may have followed a tanning course that is not appropriate for your
skin type. Check the table in chapter 'Tanning and your health' , section
'Tanning sessions: how often and how long?' .
The distance between the lamps and the surface you lie on may be larger
than prescribed. See chapter 'Preparing for use' .
When the lamps have been used for a long time, the tanning
capacity decreases. This effect only becomes noticeable after several years.
To solve this problem, select a slightly longer tanning time or have the
lamps replaced. HP8565 only: after 750 operating hours, an L appears on
the display which tells you that it is advisable to have the lamps replaced.
The tanning result depends on your skin type and the tanning course you
are taking. The first effect only becomes visible after a few sessions.
Read the last part of section 'Natural fragrances' in chapter 'Using the
appliance' .
Stop using the appliance and unplug it. Wait two seconds and put the plug
back into the wall socket. Contact your dealer or a Hapro service centre if
the problem reoccurs.
ENGLISH
15