HAPRO INNERGIZE HP8550 Bedienungsanleitung Seite 7

3 Consult the chapters 'Tanning and your health' and 'Relaxation and your health' for the
correct tanning or relax time.
4 Attach the string to the protective goggles provided.
5 Adjust the string to the length you find most comfortable.
6 Put on the protective goggles.
- Only use these protective goggles when you tan with a Hapro tanning appliance. Do not
use them for other purposes.
- The protective goggles comply with protection class II according to directive 89/686/EEC.
7 Lie down straight below the lamp unit of the appliance.
8 Set the timer to the appropriate time for the session. (Fig. 13)
Note: It can take a few seconds for the lamps to go on. This is normal.
- The appliance beeps during the last minute of the session.
- During this minute, you can reset the timer to tan the other side of your body. If you reset
the timer during this minute, you avoid the 3-minute waiting time which is necessary to let
the tanning lamps cool down after they have switched off.
Tanning or relaxing (HP8565)
1 Fully unwind the mains cord.
2 Put the plug in the wall socket.
3 Select a function by pressing the function selection button (see section 'Adjusting
functions').
4 Turn the time-selection ring to set the time (see section 'Setting the time for a tanning
or relax session').
5 Attach the string to the protective goggles provided.
6 Adjust the string to the length you find most comfortable.
7 Put on the protective goggles.
- Only use these protective goggles when you tan with a Hapro tanning appliance. Do not
use them for other purposes.
- The protective goggles comply with protection class II according to directive 89/686/EEC.
8 Lie down straight below the lamp unit of the appliance.
9 Press the START/STOP button to switch on the tanning lamps or the infrared
lamps (Fig. 14).
Note: It can take a few seconds for the lamps to go on. This is normal.
10 A flashing dot appears on the display next to the time. (Fig. 15)
The countdown of the set tanning or relax time starts.
Last minute
The appliance beeps during the last minute of the session.
- During the last minute, you can repeat the set time. Press the repeat button (
Note: The display shows the set time and starts to count down. The appliance stops beeping.
- During the last minute, you can set a new time. Turn the time-selection ring to the desired
time (1) and then press the START/STOP button (2). (Fig. 17)
ENGLISH
9
ä ). (Fig. 16)