Connecting The Device - Waeco PerfectCharge CA360 Montageanleitung

Perfect Charge CA360
6.2

Connecting the device

Connecting the battery (fig. 3, page 4)
Observe the following instructions when connecting the battery:
CAUTION!
!
 Avoid coming into contact with the battery fluid.
 Batteries with a cell short circuit may not be charged, as explo-
sive gases may form due to overheating of the battery.
 Make sure the battery terminals are clean when connecting them.
 Make sure the plug connector is fitted securely.
 Select a connection cable with a sufficient cross-section (suitable for
25 A).
 Use both the positive and both the negative connections to connect the
battery.
 Lay the cables in accordance with VDE°100 (Germany).
 Connect the negative cable directly to the negative terminal of the battery,
and not to the chassis of a vehicle or boat.
 Use the following cable colours:
– Red: positive connection
– Black: negative connection
 Do not reverse the polarity. Reversing the polarity of the connections will
cause a great spark and the internal fuses will melt.
➤ Lay the positive cable from the battery charger to the positive terminal of
the battery and connect it.
➤ Lay the negative cable from the battery charger to the negative terminal
of the battery and connect it.
230 V power supply
➤ Using the mains connection cable, connect the device to a 230 V socket
which is protected by a residual current circuit breaker.
EN
Installing the device
37