Operating The Device Safely - Waeco PerfectCharge IU812 Bedienungsanleitung

808-012.book Seite 18 Freitag, 15. Dezember 2006 11:35 11
Safety instructions
2.2
2.3
18
Downloaded from www.Manualslib.com
Safety measures when laying electric cables
Use ductwork or cable ducts if it is necessary to lay cables
through metal panels or other panels with sharp edges.
Do not lay the 220–240 V mains cable and the 12 V DC cable
together in the same cable duct (ductwork).
Do not lay the cable so that it is loose or heavily kinked.
Adhere to the specified minimum cross sections.
Fasten the cables securely.
Lay all cables so that they cannot be tripped over or damaged.

Operating the device safely

Caution - Danger of electrocution!
Do not touch exposed cables with your bare hands. This espe-
cially applies when operating the device from an AC mains.
To be able to disconnect the IU0U automatic charger quickly
from the mains in the event of danger, the socket must be close
to the device and easy accessible.
Before starting the device, ensure that the power supply line
and the plug are dry.
Always disconnect the power supply when working on the de-
vice.
Please observe that even if the fuse has blown, parts of the de-
vice may still be conducting a voltage.
Set up the device in a dry location where it is protected against
splashing water.
Protect the device against corrosive fumes and salty or moist
air.
Protect the device and the cable against rain and moisture.
Ensure good ventilation.
manuals search engine
PerfectCharge IU812