Using The Device - Waeco PerfectCharge CA360 Montageanleitung

Using the device

6.5 Connecting the fan switch
➤ Connect the switch fig. 7, page 5 on the fan contact (fig. 1 8, page 3).
When the switch is closed, the fan is off.
When the switch is open, the fan is automatically on.
Contact in
fig. 7, page 5
1
2
7 Using the device
➤ Switch off all electric consumers which are connected to the battery.
➤ Connect the battery charger to the mains.
✓Depending on the charging condition of the battery, the battery charger
starts charging or supplies a retention voltage.
✓The "Status" LED (fig. 1 2, page 3) displays the operating status (see fol-
lowing table).
Display
Orange, quickly flashing
Orange, slowly flashing
Orange, constantly lit
Green, constantly lit
Green, slowly flashing
Red, constantly lit
Red, quickly flashing
Red, slowly flashing
40
Allocation
– contact
+ contact
Meaning
Phase 1
Phase 2
Phase 3
Phase 4
Phase 5
Short circuit or defective fuse
Battery or battery charger is overheat-
ing
Battery undervoltage or overload
Perfect Charge CA360
EN