Installing The Device; Fastening The Device - Waeco PerfectCharge CA360 Montageanleitung

Perfect Charge CA360
5: U phase (float)
After the U0 phase, the battery charger switches to conservation charging
function (see "Technical data" on page 44) (U phase).
If DC loads are connected, they are powered by the device. Only if the power
required exceeds the capacity of the device is this surplus power provided by
the battery. The battery is then discharged until the device re-enters the I
phase and charges the battery.
6: 12-day conditioning
Every 12 days, the battery charger switches back to phase 1 in order to re-
vive the battery. This prevents any fatigue symptoms such as sulphation.
6

Installing the device

6.1

Fastening the device

When selecting the installation location, observe the following instructions:
 The device can be installed horizontally or vertically.
 Do not install the device
– In wet or damp environments
– In dusty environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
 The place of installation must be well ventilated. A ventilation system must
be available for installations in small, enclosed spaces. The clearance
around the device must be at least 25 cm.
 The air inlet on the underside and the air outlet on the back of the device
must remain clear.
 For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the device under load can
lead to reduced output.
 The device must be installed on a level and sufficiently sturdy surface.
 Do not install the device in the same area as the batteries.
 Do not install the device above batteries, because they can emit corrosive
sulphur fumes that will damage the device.
EN
Installing the device
35