Standby For Remote Operation - Sentiotec infrabox Montage- Und Gebrauchsanweisungen

Instructions for use for the user

9.5. Standby for remote operation

To activate this function, observe the following procedure:
WARNING!
Risk of fire
● Before the infrared controller is switched on, make sure that no flam-
mable objects have been hung over the infrared heater or on the
infrared plate.
1. Check the cabin to make sure that no flammable objects are hanging over
the infrared heater/infrared plate.
2. Close the doors of the cabin.
3. Press Mode button 4 for approx. 3 seconds (when switched off).
► The display for Standby for remote operation 8 flashes.
4. The cabin is ready to operate once the 230 V is connected up.
To deactivate the "Standby for remote operation" function, observe the following
procedure:
1. Press the ON/OFF button 3.
► The controller starts.
2. Repress the ON/OFF button 3.
► The controller switches off.
► The function for "Standby for remote operation" is deactivated.
The EN 60335-2-35 states that infrared controllers with remote start
function must be activated again to "Standby for remote operation" mode
before each remote start procedure.
p. 38/44