Installing Water Filter; Installation Requirements; Connection Of The Water Pipe To The Refrigerator - Grundig GQN 1360 XA++ Bedienungsanleitung

Installing Water Filter

(in some models)
Two different water sources may
be connected to the refrigerator for
water supply: the mains cold water
supply and water in a jug.

Installation Requirements

A pump should be used for jug water
■
usage.
Check that the parts stated below
■
are supplied with your appliance.
1. Union for connection of the water
pipe to the rear of the appliance.
(If it does not fit, provide it from the
nearest authorized service.)
2. 2 pieces of pipe clips (In case
required to secure the water pipe)
Note: Since the following parts are
■
not required in use with a jug, they
may not be found in the product you
purchased.
3. 5-meter long water pipe (1/4 inch in
diameter)
4. Cold mains water valve with mesh
filter (Tap Adapter)
5. Water Filter or externally
connectable filter to be fitted
to the bracket inside the fridge
compartment.
Place where the external filter is going
to be fitted should be determined
3
1
4 5
2
first. (Applies to the filter being
used outside the refrigerator.) Then,
determine the distance between
the filter and the refrigerator and
required hose lengths from the filter
to the refrigerator water inlet.
Water filter must be hold upright as
shown in the figure. It is important
to properly attach the filter to water
inlet and water outlet points.
After attaching the filter, do not use first
3-4 glasses of water.
Connection of the Water Pipe to
the Refrigerator
1. After installing the union onto the
■
water pipe, insert the water pipe to
the refrigerator inlet valve by pressing
downwards firmly.
2. Fix union as seen in the opposite
■
figure, by squeezing by hand on the
refrigerator inlet valve.
(a- Water Pipe, b-Union, c-Valve)
C
Note 1: You should not need to
■
tighten the union with a tool to achieve
water tight assembly. In case of a leak
use a spanner or a pair of pliers to
tighten the union.
a
a
b
2
1
c
45
ENGLISH