Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.1 Energy Saver
This option decreases the temperature in
the last rinse phase.
The use of this option decreases the ener-
gy consumption (up to 25%) and the pro-
gramme duration.
The dishes can be wet at the end of the
programme.
How to activate the Energy Saver
option
1. Press Energy Saver. The related indi-
cator comes on. In the display you can
see the update of the programme du-
ration.
• If the option is not applicable to the
programme, the related indicator
flashes quickly 3 times and then
goes off.
5.2 Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the use of rinse
aid and salt. The related indicators stay
off.
The programme duration can increase.
How to activate the Multitab option
1. Press Multitab, the related indicator
comes on.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse
aid.
5.3 Acoustic signals
The acoustic signals operate when the
appliance has a malfunction, when the
adjustment of the level of the water soft-
ener occurs and when the programme is
completed.
By default, the acoustic signals are on,
but it is possible to deactivate them.
How to deactivate the acoustic
signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'Set-
ting and starting a programme'.
2. Press and hold, at the same time, but-
ton
and button
tors of buttons
start to flash.
3. Press button
•
The indicators of buttons
and
go off.
• The indicator of button
ues to flash.
• The display shows the current set-
ting.
Acoustic signal on.
Acoustic signal off.
4. Press button
ting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
5.4 How to set the colour of the
TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are 9 different colours
available.
It is also possible to deactivate the Time-
Beam.
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'Set-
ting and starting a programme'.
2. Press and hold, at the same time, but-
ton
and button
tors of buttons
start to flash.
3. Press button
•
The indicators of buttons
and
go off.
ENGLISH
59
until the indica-
,
,
and
.
,
contin-
to change the set-
until the indica-
,
,
and
.
,
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
