Setting And Starting A Programme; Setting Mode - Electrolux GA60GLV222 Benutzerinformation

7.2 Setting and starting a
programme

Setting mode

For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the ap-
pliance. The appliance is in setting mode
when the display shows 2 horizontal sta-
tus bars. If the control panel does not
show this condition, press Reset.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Press one of the programme buttons
again and again until the display
shows the number of the programme
you want to start.
• The programme number flashes in
the display.
• If you want you can set the applica-
ble options.
4. Close the appliance door, the pro-
gramme starts. The programme dura-
tion starts to decrease with steps of 1
minute.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay start button again and
again until the display shows the delay
time you want to set (from 1 to 24
hours).
• The delay time flashes in the display
and the delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is completed,
the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press Reset. The display shows 2
horizontal status bars.
2. Set the programme again.
Cancelling the programme
1. Press Reset. The display shows 2
horizontal status bars.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
The display shows 0:00 and the end indi-
cator comes on.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off but-
ton, the AUTO OFF function auto-
matically deactivates the appli-
ance a few minutes after the end
of the programme.
This helps to decrease the energy
consumption,
Important
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and on
the door of the appliance. Stainless
steel becomes cool more quickly than
the dishes.
ENGLISH 63