Relay - Feig Electronic OBID ID ISC.MR200-EP Montageanleitung

®
OBID i-scan

3.11.2 Relay

A changeover relay is provided.
Terminal Abbreviation
1
2
3
Table 3-10: Relay output pinouts
Notes:
• The relay outputs are configured for max. 24 V DC / 2 A.
• The relay outputs are intended for switching resistive loads only. If an inductive load is
used, the relay contacts must be protected by means of an external protection circuit.
Fig. 3-12: Internal and possible external wiring of the relay output
FEIG ELECTRONIC GmbH
Montage / Installation
COM Working contact
NC Normally closed
NO Normally open
ID ISC.MR200
X4
COM
1
NC
2
NO
3
Page 44 of 53
Description
U
ID ISC.MR200-W/EP
ext.
M50808-4de-ID-B.doc