Approval; Europe (Ce); Usa (Fcc) - Feig Electronic OBID ID ISC.MR200-EP Montageanleitung

®
OBID i-scan

6.1 Approval

6.1.1 Europe (CE)

When properly used, the RF system is in conformance with the essential requirements of Article 3
and the other relevant provisions of the R&TTE Directive 1995/5/EC of March 99.
Equipment Classification according to ETSI EN 300 330 and ETSI EN 301 489: Class 1

6.1.2 USA (FCC)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Unauthorized modifications may void the authority granted under Federal communica-
tions Commission Rules permitting the operation of this device.
Warning: Changes or modification made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
Approval per FCC 47 CFR CH. I Part 15 applies to use with following antennas
Antenna
ID ISC.ANT300/300
ID ISC.ANT800/600
Table 6-1: Approved Antennas
FEIG ELECTRONIC GmbH
Montage / Installation
FCC ID: PJMMR200
Reader configuration
Reduced output power (1 W)
Reduced output power plus 3 dB attenuation
Page 52 of 53
ID ISC.MR200-W/EP
M50808-4de-ID-B.doc