Relay - Feig Electronic OBID ID ISC.LRU2000 Montageanleitung

®
OBID i-scan

2.7.2 Relay

A relay output is provided in the form of a changeover relay.
Terminal Abbreviation
1
2
3
Table 2-8: Relay output pin-outs
Notes:
• The relay output is configured for max. 24 V DC / 2 A.
• The relay output is intended for switching resistive loads only. If an inductive load is
connected, the relay contacts must be protected by means of an external protection
circuit.
U
ext.
Fig. 2-7: Internal and possible external wiring of the relay output
FEIG ELECTRONIC GmbH
Installation
COM Working contact
NC Normally closed
NO Normally open
Page 43 of 56
Description
X9
3 2 1
ID ISC.LRU2000
M60801-0de-ID-B.doc