Feig Electronic OBID ID ISC.MR200-EP Montageanleitung Seite 51

®
OBID i-scan
Functional Properties
•
EEPROM (for parameters)
•
FLASH
•
Protocol Modes
•
Supported transponders
•
Optical indicators
Ambient Conditions
•
Temperature range
- Operating
- Storage
•
Vibration
•
Shock
Applicable Standards
•
RF approval
- Europe
- USA
•
EMC
•
Safety
- Low Voltage
- Human Exposure
FEIG ELECTRONIC GmbH
Montage / Installation
10,000 write cycles
Software can be updated on interface
- FEIG ISO HOST
- BRM (Data Filtering and Data Buffering
- Scan Mode
- Notification Mode
•
ISO15693, ISO18000-3-A
(EM HF ISO Chips, Fujitsu HF ISO Chips,
KSW Sensor Chips, Infineon my-d,
NXP I-Code, STM ISO Chips, TI Tag-it)
•
•
I Code UID, I Code EPC
Optional
5 LED´s for diagnosing the operating status
-20°C to +60°C (-4°F to 140°F)
-25°C to +85°C (-13°F to 185°F)
EN60068-2-6
10 Hz to 150 Hz : 0.075 mm / 1 g
EN60068-2-27
Acceleration
EN 300 330
FCC 47 CFR Part 15
EN 301 489
EN 60950
EN 50364
Page 51 of 53
ID ISC.MR200-W/EP
: 30 g
M50808-4de-ID-B.doc