Dc Voltage On The Rf Antenna Terminal X2 - Feig Electronic OBID ID ISC.MR200-EP Montageanleitung

®
OBID i-scan

3.9 DC voltage on the RF antenna terminal X2

Jumper J10 can be used to provide DC voltage on antenna terminal X2. This DC voltage is used to
power the dynamic antenna tuner (ID ISC.DAT).
Note:
•
The DC voltage is only designed for to power the ID ISC.DAT dynamic antenna tuner.
The maximum DC current loading is 150mA.
•
Connecting other antennas to this DC voltage can destroy them.
•
By connecting other devices (e.g. VSWR-Meter) it must be checked if these devices are
suitable for DC voltage.
FEIG ELECTRONIC GmbH
Montage / Installation
1
X2
Fig. 3-9: Position Jumper J10
J10
DC voltage on
antenna terminal
Table 3-6: Jumper J10 configuration
J10
1-2
No
(Default)
Page 40 of 53
ID ISC.MR200-W/EP
2-3
Yes
M50808-4de-ID-B.doc