Pelgrim IDK 660 Anleitung Seite 94

16
Symptom
Text appears in the displays when
the appliance is first connected.
The fan runs on for several
minutes after the hob has been
switched off.
A slight smell is noticeable the
first few times the hob is used.
You can hear a ticking sound in
your hob.
The pans make a noise while
cooking.
You have switched a cooking
zone on but the display keeps
flashing.
A cooking zone suddenly stops
working and you hear a signal.
The hob is not working and
nothing appears in the display.
A fuse blows as soon as the hob
is switched on.
Fault code F01....F09 or F10.
Fault code IE03, IE09.
Other fault codes.
Fault code 1E01, 2E01, 3E01 or
4E01
Fault code 1E10.
Fault code F99.
Continuous bleep.
troubleshooting
Possible cause
This is the standard set-up
routine.
The hob is cooling.
The new appliance heating up.
Ticking can also occur at lower
settings.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is not
suitable for induction cooking or
has a diameter of less than 12 cm.
The preset time has ended.
There is no power supply due to
a defective cable or a faulty
connection.
The hob has been wrongly
connected.
A button has been pressed for
too long or something is lying on
a button.
The hob has been wrongly
connected or the mains voltage is
too low.
Defective generator.
The hob has overheated.
The hob has been wrongly
connected or the mains voltage is
too high.
You pressed two buttons at once.
The hob has been wrongly
connected or the main voltage is
too high.
Solution
Normal operation.
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
Normal operation.
At high settings this is
perfectly normal for some
pans. It will not damage
either the pans or the hob.
Use a suitable pan, see page
12.
Switch the bleep off using
the + or – button on the
timer.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Remove the object and
switch the hob on again.
Check the connection.
Contact your electricity
supplier if the problem
continues.
Contact the service
department.
The hob has been switched
off due to overheating. Let
the hob cool down and then
use a lower setting.
Have the connection
changed. Contact the service
department.
Press 1 button at a time.
Have the connection
changed.