Stand Maintenance - Husqvarna DMS 160 A Bedienungsanweisung

Replacing the carbon brushes
The carbon brushes must be removed and checked regularly.
Weekly if the machine is used daily or at longer intervals if the
machine is used more seldom. The area of wear should be
even and undamaged.
Both carbon brushes must always be replaced as a pair, but
one at a time. Do as follows:
1 Remove the cover for the carbon brushes using a flat wide
screwdriver.
2 Carefully remove the carbon brushes. The carbon
brushes must be replaced if there is less than 6 mm
remaining on the brushes.
3 Fit new carbon brushes.
4 Screw on the brush cover.
5 Let the machine idle for 10 minutes to run in the new
carbon brushes.
Daily maintenance
1 Check that nuts and screws are tight.
2 Check that the power switch unit works smoothly.
3 Clean the outside of the machine.
4 Check and clean the cooling air openings.
5 Check that the cord and extension cord are intact and in
good condition.

Stand maintenance

Cleaning and lubrication
IMPORTANT! Remove the drill motor. For maintenance of
the drill motor see maintenance of the drill motor.
• It is important that the drill stand is kept clean for
functionality to be maintained.
• Clean the stand using a high pressure washer and then
wipe dry.
• Lubricate the moving parts on the stand. Apply grease to
counteract corrosion on the contact surfaces.
MAINTENANCE
Repairs
IMPORTANT! All types of repairs may only be carried out by
authorised repairmen. This is so that the operators are not
exposed to great risks.
Daily maintenance
1 Check that nuts and screws are tight.
2 Clean the outside of the machine.
– 15
English