Wha T Is What; What Is What On The Dr Illing Machine - Husqvarna DMS 160 A Bedienungsanweisung

What is what on the drilling mac hine?
1 Drill spindle
2 Water connector
3 Screws holding together the gearbox and the motor.
4 Power switch
5 Cover for slip clutch (SMC)
6 Carbon brush cover
7 Load/power indication (LCS-Load control system).
4 –
English
WHA T IS WHA T?
8 Locking knob
9 Screws (4) for feeder rear section and gearbox
10 Feeder handle
11 Feeder rear section
12 PRCD Ground fault circuit interrupter
13 Spanners
14 Operator ' s manual