Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna DMS 160 A Bedienungsanweisung

Symbols on the mac hine:
W ARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or fatal
injury to the operator or others.
Please read the operator's manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
• Breathing mask
This product is in accordance with applicable
EC directives.
En vironmental marking. Symbols on the
product or its packaging indicate that this
product cannot be handled as domestic
waste. It must instead be submitted to an
appropriate recycling station for the recovery
of electrical and electronic equipment.
By ensuring that this product is taken care of
correctly, you can help to counteract the
potential negative impact on the environment and people that
can otherwise result through the incorrect waste
management of this product.
For more detailed information about recycling this product,
contact your municipality, your domestic waste service or the
shop from where you purchased the product.
Ensure that water cannot leak into the
machine when drilling in the ceiling. Use an
appropriate water collector and cover the
machine in plastic, but do not cover the air
intakes and air outlets.
The drilling machine must be suitable and
designed for the size of drill bit. The max drill bit
diameter is stated on the machine.
Use a drill suitable for the work.
Load/power indication (LCS-Load
control system).
Check that the ceiling is strong enough. The
ceiling should be solid.
2 –
English
KEY T O SYMBOLS
Make sure that the fork grips in the inner ear.
Tighten using a suitable spanner.
Lock the nut using a 30 mm spanner. Check
the lock nut on the L-handle. Make sure that it
is tightened.
WARNING! Dust forms when drilling,
which can cause injuries if inhaled. Use
an approved breathing mask. Always
provide for good ventilation.
Other symbols/decals on the mac hine
refer to special certification
requirements for certain markets.
Symbols in the operator' s manual:
Inspection and/or maintenance should
be carried out with the motor switched
off and the plug disconnected.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Ø