Safety Instructions For Maintenance; Operation - Husqvarna DM 230 Bedienungsanweisung

3. Release the power switch to stop the product.

Safety instructions for maintenance

WARNING:
maintenance should be carried out with
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 16 .
3. Make sure that the nominal voltage and current in
the power outlet is the same as the voltage and
current of the product.
4. Make sure that the PRCD is started. Refer to
on page 8 and To examine the PRCD on page 9 .
5. Make sure that the work area is clean and bright.
6. Use personal protective equipment. Refer to
Personal protective equipment on page 8 .
7. Make sure that the product is installed correctly. The
drill bit must be attached correctly.
8. If you use the product with a drill stand, read the
operator's manual for the drill stand carefully and
make sure that you understand the instructions.
Make sure that the product is attached correctly.
9. If you do not use a drill stand, the auxiliary handle
must be connected and fully tightened. Refer to
set the auxiliary handle in an applicable position on
page 11 .
10. When you operate the product dry, use a dust
To prepare the product for dry
extractor. Refer to
drilling on page 11 .
11. When you operate the product wet, make sure that
the water system is not damaged and use the water
connector. Refer to
drilling on page 12 .
10
Inspection and/or
Maintenance
To prepare the product for wet
• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.

Operation

12. When you do inverted drilling, make sure that you
comply to the applicable instructions. Refer to
prepare the product for inverted drilling on page 12 .
To use the product with a drill stand
PRCD
To attach the product to a drill stand, refer to the manual
for the drill stand.
• Remove the auxiliary handle when you use the
product with a drill stand.
• Always use a drill stand if you stand on a scaffold
when you drill.
• Make sure that the drill stand is correctly attached.
• Make sure that the product is correctly attached in
To
the drill stand.
• Use only with approved Husqvarna drill stands.
Refer to
• Attach the trigger lock bracket. Refer to
trigger lock bracket to the product on page 10 .
To attach the trigger lock bracket to the
product
The trigger lock bracket must only be used when you
use a drill stand. The trigger lock bracket pushes and
holds the power switch to start position.
the motor switched off and the plug
disconnected.
CAUTION:
If you use a drill stand, read
this section carefully.
CAUTION:
Read the operator's manual
for the drill stand carefully.
Accessories on page 21 .
1473 - 001 - 04.04.2022
To
To attach the