Abicor Binzel ABITIG MT 500W Betriebsanleitung Seite 35

®
ABITIG MT
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany see TRBS
1203).
• As the TIG welding torch is integrated into a welding system, the operating instructions of
the welding components, such as welding torch and welding power supply, must be
observed during operation.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-13.
1 Disconnect the TIG welding torch from the power supply.
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines
must be observed. Observe the regulations on the disposal of electronic scrap and dispose of
it at your local waste disposal site.
 11 Disassembly on page EN-16
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works
and are, thus, almost infinitely recyclable. The plastic materials used are marked in preparation
for sorting and separation of the materials for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system.
These materials must be stored, transported and disposed of in suitable containers. Please
observe the relevant local regulations and disposal instructions in the safety data sheets
specified by the consumables' manufacturer. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables'
manufacturer.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability
to recycle packaging materials is always considered during their selection.
BAL.0107 • 2018-11-12
12 Disposal
EN - 17