Maintenance; Repairs; Daily Maintenance - Husqvarna WS 460 Bedienungsanweisung

Maintenance

IMPORTANT! Inspection and/or maintenance should be
carried out with the motor switched off and the plug
disconnected.
In addition to the daily maintenance such as cleaning and
lubrication, the machine must be serviced. After 50 hours of
cutting, the machine should be serviced at an accredited
Husqvarna workshop. The saw should then be serviced after
every 100 hours of operation. The service is important so that
as the user you have a machine that works as effectively as
possible for a long time.
Oil change cutting arm
There is an oil plug for draining the oil located on the cutting
arm. This plug should be cleaned when changing the oil. The
new oil is filled through the hole where the oil plug sits.
The cutting arm contains 1 dl of Husqvarna Oil 150, a
transmission oil of the type EP 150. The oil should be
replaced for the first time in connection with the first service.
A 1 dl bottle of oil is supplied when the machine is new.
IMPORTANT! Used engine oil and transmission oil is
hazardous to health and must not be disposed of in the
ground or out of doors.
Lubricating the gears
There are two grease nipples on every saw unit. Through
these the gears for the feeding engines can be lubricated.
Lubricate daily or at least every 30 hours of operation. Use
VEIDEC POWER LUBE or corresponding grease.
16 –
English
MAINTENANCE
Grease the blade spindle
In order for the blade spindle to be fitted as easily as possible,
it may be necessary to grease the hexagonal blade spindle.
At the same time check that the hexagon is not damaged.
IMPORTANT! All types of repairs may only be carried out by
authorised repairmen. This is so that the operators are not
exposed to great risks.

Repairs

IMPORTANT! All types of repairs may only be carried out by
authorised repairmen. This is so that the operators are not
exposed to great risks.

Daily maintenance

1 Ensure the blades are not cracked or damaged in any
other way.
2 Check that the blade guard is not damaged or cracked.
Replace the blade guard if it is exposed to impact or is
cracked.
3 Clean the outside of the machine.
Do not use a high pressure washer to clean the saw.
4 Check that all couplings, connections and hydraulic hoses
are in full working order.