Maintenance & Lubrication - Husqvarna FS 410 D Bedienungsanweisung

SCHEDULED MAINTENANCE QUICK REFERENCE:
Before performing any maintenance, ALWAYS park the machine on a level surface with the engine "OFF" and
the engine switch set in the "OFF" position. Let the machine cool down! Other maintenance and repairs
should only be carried out by a qualified technician.
SERVICE DAILY:
. Check engine oil level.
. Check blade guard for damage.
3. Check engine air filter, replace if dirty. Service sooner
if used in dusty conditions.
. Clean machine daily.
LUBRICATION:
Depth Control Grease Fitting (X): A grease
fitting allows lubrication of Blade Depth Control
(EE) screw. To access this grease fitting:
• Raise the Diamond Blade (H) to maximum height.
Open Tool Compartment (BB), temporarily remove opera-
tion manual bag.
• Grease fitting (X) is located near top of Blade Depth
Control (EE) Tube.
• Add Grease to the fitting. Raise and lower the machine
a few times to circulate the grease through the tube.
• Replace Operation Manual Bag, close Tool Compart-
ment (BB) door.
Engine Oil:
Checking Engine Oil:
Check that engine oil level is correct.
Engine Oil Dipstick (Z) is located on front of
engine. Refill engine oil in dipstick hole. When
checking oil level, Engine Oil Dipstick (Z) should
not be screwed in.
Because engine often operates at an angle, check oil
level with engine horizontal. Check frequently to ensure
that oil level never falls below lower mark on dipstick.
0W0 oil is recommended.
See engine operation manual for more information.

MAINTENANCE & LUBRICATION
SERVICE EVERY 50 HOURS:
1. Replace engine oil and filter.
2. Clean engine/motor air fins.
. Lubricate Depth Control Grease Fitting (X).
. Check wheels for wear or damage.
. Check blade drive belt tension.