Fit The Blade; Flush Cutting - Husqvarna WS 460 Bedienungsanweisung

Fit the blade

WARNING! Never mount or dismount the
!
blade or blade guard without first switching
off the hydraulic unit and disconnecting the
hydraulic hoses running to the saw unit.
Carelessness can result in serious personal
injury or even death.
1 Start by removing any dirt from the contact surfaces on
the blade flange and blade.
2 Check the blade's direction of rotation. The blade shall
rotate with the exposed part of the diamond in the
rotational direction of the blade.
3 Screw together the outer blade flange, blade and blade
flange hub (tightening torque 70-80 Nm).
4 Hang the blade with the blade flange and blade flange hub
fitted on the cutting arm (blade is not shown in the figure).
5 Turn the blade flange hub carefully so that it slides into one
of the tracks in the pivot arm and lands in the correct
position to be screwed fast.
ASSEMBLY
6 Press in the blade spindle into the cutting arm at the same
time as the blade is rotated carefully. When the blade
spindle can no longer be pressed in by hand it should be
tightened using the supplied 18-spanner until it is properly
secured (tightening torque 70-80 Nm).
!

Flush cutting

When cutting flush, screw the blade directly onto the blade
flange hub.
A=110 mm/4.33 inch, 6xM10
B=89 mm/3.5 inch, 6xM8
C=144 mm/5.7 inch
WARNING! Exercise care when assembling
the blade so that it does not risk becoming
loose when cutting. Carelessness can result
in serious personal injury or even death.
– 11
English