Mount The Saw Carriage And Saw - Husqvarna WS 460 Bedienungsanweisung

Mount the saw carriage and saw

Track 360
1 Push the retention rollers outward to the release position.
This allows the saw carriage to be placed on the track with
no interference.
For vertical cuts, the rail must be mounted with the saw
carriage lock handle upwards. This to facilitate fitting the
saw unit.
2 Place the saw carriage on the track. Make sure that the
pinion gear meshes properly with he track rack and that
the saw is down firmly on the track. Push the retention
rollers inward to the lock position.
3 Fit the saw body in the saw carriage by lifting the saw body
into position. When the saw is lifted into position, the
locking handle moves up into an intermediate position. In
this position the saw remains in the saw carriage without
it needing to be held. However, it is not sufficiently secured
to begin cutting.
4 To secure the saw, lift the locking handle towards the saw
until the handle locks.
WARNING! To cut without the saw securely
!
assembled in the saw carriage and rail is
associated with mortal danger.
10 –
English
ASSEMBLY
Track 400 series
The saw carriage is mounted on the rail at delivery. The
carriage can be dismounted from the rail by removing the end
stop on the rail and pulling the carriage away.
1 Fit the saw body in the saw carriage by lifting the saw body
into position. When the saw is lifted into position, the
locking handle moves up into an intermediate position. In
this position the saw remains in the saw carriage without
it needing to be held. However, it is not sufficiently secured
to begin cutting.
2 To secure the saw, lift the locking handle towards the saw
until the handle locks.
!
WARNING! To cut without the saw securely
assembled in the saw carriage and rail is
associated with mortal danger.