Ws 460; Assembly; Mount Wall Mountings And Rail - Husqvarna WS 460 Bedienungsanweisung

Mount wall mountings and rail

WS 460 is supplied with two types of wall mounting and rail.
The type of rail supplied depends on the market and the
customer's requirements.
Track 360
1 Mark off the cutting line and mark off the expander bolts
holes 165 mm (6,5") from the cutting line.
2 Drill 15 mm (5/8") holes for the M12 (1/2") expander bolts.
3 If the expander bolt pulls out when the mount is fixed or
when mounting on brick, stone or hollow concrete walls, it
may be necessary to "through-bolt" with a piece of thread
bar and a large backing plate installed on the opposite
side of the wall.
4 Hang the wall mountings loosely from the expander bolts,
using M6S 12 x 70 (1/2"x2") or similar.
5 Level the brackets with the leveling screws so that the top
of the brackets are parallel with the plane of the wall.
6 Secure the track to the brackets with T-washers and
capscrews. The gear rack should be to the side of the
track nearest the cut line.
7 Adjust the distance between the cutting line and the wall
mounting. The distance between the edge and the inner
face of the saw cut should be 95 mm (3,7"). Tighten the
expander bolts.
IMPORTANT! Make sure that the safety stops are fastened
at each end of the track to prevent the saw from running off
the track.

ASSEMBLY

Track 400 series
1 Mark off the cutting line and mark off the expander bolts
holes 165 mm (6.5") from the cutting line.
2 Drill 15 mm (5/8") holes for the M12 (1/2") expander bolts.
3 Hang the wall mountings loosely from the expander bolts,
using M6S 12 x 70 (1/2"x2") or similar.
4 Level the brackets with the leveling screws so that the top
of the brackets are parallel with the plane of the wall.
5 Place the rail in the wall mountings and tighten the
compression washers.
For vertical cuts, the rail must be mounted with the saw
carriage lock handle upwards. This to facilitate fitting the
saw unit.
6 Adjust the distance between the cutting line and the wall
mounting. The distance between the edge and the inner
face of the saw cut should be 89 mm (3.5"). Tighten the
expander bolts.
IMPORTANT! Only use the connectors supplied when
purchasing the saw as older connectors are not designed
for the WS 400 series.
– 9
English