Troubleshooting; Technical Specifications - ECG MH 158 Bedienungsanleitung

Cleaning:
• Unplug the power cord.
• Lift the lid and take out all the accessories. Wash
the accessories in soapy water.
• Always remove fi rst hot oil or any other liquid
from the container with non-stick surface.
• Take out the container with non-stick surface,
remove leftovers of liquid or food and let it cool.
Fill the container with non-stick surface with
water with gentle detergent. Do not use abrasive
materials to clean.
• You can wipe the exterior using moistened
sponge. Never use abrasive sponge pads or
powders.
Maintenance:
• Make sure that the container with non-stick
surface is perfectly dry before using it.
• Never pour cold water in the container with non-
stick surface.

TROUBLESHOOTING

Problem
The power LED does not work
The temperature is too low or too
high

TECHNICAL SPECIFICATIONS

Oil container capacity 2,9 l
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 1500 W
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into
plastic recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specifi ed location for recycling electric and electronic equipment. Prevent
negative impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the
product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
The instruction manual is available at website www.ecg-electro.eu.
Changes in text and technical parameters reserved.
• Do not use abrasive cleaners or scouring pads,
you could damage the non-stick surface.
• Use only wooden or heat-resistant plastic
utensils when cooking to prevent damage to the
non-stick surface.
• Never use metal utensils.
• Never immerse the base (external unit) in water
or any other liquid. Wipe with damp cloth only.
• Never pour water in hot oil.
Solution
Make sure that the container with non-stick surface is properly
attached to the base. Check if the power cord is correctly plugged in.
Set the required temperature. Turning the controller to the right
increases temperature, turning to the left lowers it.
GB
08/05
29