Cleaning And Maintenance; Troubleshooting; Technical Specifications - ECG EH 1886 Double Bedienungsanleitung

• To ensure safety when finished, turn the switch to the off position and unplug the power cord. When the
pot cools down entirely, you can clean it.

CLEANING AND MAINTENANCE

After each use
• After use, switch off the appliance and unplug the power cord.
• Allow all parts to cool before cleaning.
• Wash the steam insert and the lid in warm water with detergent, rinse and dry.
• We do not recommend washing parts of the appliance in a dishwasher, aggressive agents and hot water
can cause stains and other damage to parts of the appliance.
• Do not use abrasive cleaners, scouring pads or wire brushes and abrasive sponges, as those could damage
the non-stick surface.
Do not immerse the body of the appliance in water or other liquids.
•
• You can wipe the stainless steel body of the pot with a damp cloth and then dry it.

TROUBLESHOOTING

PROBLEM
The hot plate is
not hot
Indicator is
1
not on.
The hot plate
is hot
The
The hot plate is
2 indicator is
not hot
on.
The cooking time is too long
3 or it is difficult to bring water
to boil.
You can hear creaking sounds
4
during cooking.

TECHNICAL SPECIFICATIONS

Capacity: 3 l
Nominal voltage: 220–240 V~ 50–60 Hz
Nominal input power: 900 W
CAUSE
The power is not connected
1. The connection inside the
appliance is loose.
2. The indicator light is
damaged.
1. Connection is loose.
2. The electric heating pipe
was burned.
1. The pot was deformed.
2. The temperature is not set
high enough.
It is caused by the heating
plate expanding with heat
during heating
SOLUTION
Check if the switch / plug / output fuse
and power cord is all right or not.
1. Reconnect them.
2. Replace them.
1. Contact your after-sales service
2. Contact your after-sales service
1. Adjust the pot to ensure full
contact with the heating plate.
2. Turn the switch to the right to set a
higher temperature.
This is normal, you can continue to use
the appliance
7