Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
The indicator will flash for 5 seconds. Then lift the container and the red indicator will go off. After you
finish stirring, pour the hot chocolate into a cup.
Standby mode
If you press any button while removing the container from the base, the frother will remain in standby mode.
The blue and red indicators will flash simultaneously for 5 seconds.
TIPS AND TRICKS
The following tips will help you make delicious milk froth.
•
When the milk frother is operating, it is necessary to immediately prepare coffee or hot chocolate.
•
For the production of milk froth is best to use whole milk (with a fat content higher than 3).
•
This frother can make froth from cold milk. During operation, however, the appliance emits a small amount
of heat, thanks to which the frothed milk will not be as cold as before.
•
The milk can be heated to a maximum of 60-70° C, which is the ideal temperature range for making coffee.
•
The frother and its attachments are relatively small. Therefore, it is necessary to store the appliance in a safe
place to prevent loss or endangerment of children's health.
•
The frother must be cleaned right after each use. Use a dry cloth to wipe off the foam.
TROUBLESHOOTING
Problem
The light is not on,
the frother does not
work
After starting the
frother stopped
working.
The motor does not
work
Heating does not
work
Burnt milk
MAINTENANCE AND CLEANING
Always unplug the power cord from the wall outlet before cleaning and let the appliance cool off thoroughly!
Remove the frother from the base before cleaning. Never immerse the base in water!
Frother container: Clean immediately after each use. Clean the walls with water with detergent and soft
•
cloth. Then wipe it dry.
Lid: Remove the lid and the silicon seal from the frother. Rinse it with water.
•
•
Exterior surface: Clean with dry cloth. Never use aggressive cleaning agents, hard nylon or wire brushes
that could scratch the surface. Never use any metal or sharp objects or abrasive powders for cleaning.
8
Cause
The power cord is not properly plugged
in.
Poor contact between the frother and the
base.
The electrical outlet is not under voltage.
Appliance malfunction.
The frother is too hot.
The frother is damaged by immersion in
water.
The frother was not cleaned after use, the
milk clogged the mechanism.
Damaged motor.
Appliance malfunction.
Incorrect amount of milk
The frother was used repeatedly without
being washed.
Solution
Plug the power cord in the outlet
properly.
Attach the frother to the base
properly.
Try to use another outlet.
Bring it to the service centre.
Rinse with cold water.
Bring it to the service centre.
Clean and then move the drive shaft
of the motor by hand.
Bring it to the service centre.
Bring it to the service centre.
Use the correct amount of milk
Clean after every use.
Werbung
Inhaltsverzeichnis
Fehlerbehebung
