Cleaning And Maintenance; Troubleshooting; Technical Data - ECG SP 466 Bedienungsanleitung

Note:
• The maximum continuous operation is 20 seconds, let it cool down for at least 2 minutes before using it again.
Otherwise, it might cause overheating and damage.
• Do not use the chopping blade for hard foods like coff ee beans, ice cubes, spices or chocolate.

CLEANING AND MAINTENANCE

Disconnect the appliance from the electrical outlet prior to performing any maintenance. Cleaning should be
always performed on a cooled appliance!
Wipe the base with wet cloth. Never clean it under running water, do not rinse it and do not immerse it in
water! You can clean other parts under running water. Do not wash in the dishwasher. The plastic parts may
change colour after processing coloured foods. Do not use scrubber, abrasive cleaners or solvents. Before
storing the chopper make sure that it is completely cooled off , that it is clean and dry.

TROUBLESHOOTING

Problem
Motor does not work
The motor is overheating
and smell is coming out.
Unsatisfactory results
when chopping meat

TECHNICAL DATA

Capacity of the vessel 1 l
Noise level: 80 dB
Nominal voltage: 220-240 V~ 50/60 Hz
Nominal input power: 250 W
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into plastic
recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specifi ed location for recycling electric and electronic equipment. Prevent negative
impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
GB
The instruction manual is available at website www.ecg.cz.
Changes in text and technical parameters reserved.
20
Possible cause
The base, the container lid and
the blade unit are not assembled
correctly.
Too much food or too long running
time.
The meat pieces are too large or there
is too much meat.
Solution
Place the base with the motor again
correctly on the lid of the container
and on the shaft of the blade unit.
Limit the amount of food and use
again after it cools down.
Limit the amount or the size.
08/05